How to Configure the Scan System for the BSAPScanner

Complete the following steps to configure the scan system for the BSAP scan task:

1. Configure the OpenBSI utilities for the "communication line".
2. Configure the RTAP scan system by specifying the appropriate information in the scan system configuration area of the database.
3. Run RTAP with the BSAPScanner included as an entry in RtapEnvTable, with the autostart phase field set to 0 (zero).

Refer to the Scan System section in the RTAP/Plus Integration Manual for configuration of device-independent sections of the scan system. The following sections describe the device-dependent information for the BSAP scan task, including the following:

1. The point format for the device specific information.
2. The device-dependent attributes and fields that you must configure.
3. The device-dependent attributes and fields the scan system sets.
4. The device-independent attributes that the BSAPScanner uses in a special way.

Italicized attribute and field names in the following tables represent attributes and fields that you must assign values to. Non italicized entries are set or used by the system.

See also:

• Configuring Scan Configuration Point
• Configuring the Communication Port Point
• Configuring the Scan Device Point
• Configuring the Scan Input Table
• Configuring the Scan Output Table
• Configuring RtapEnvTable