Configuring the Modbus Scan Device Point

The following table outlines the device-dependent information that you must configure in the scan device point for the ModbusScanner:

`Pathname - . . . :scan configuration:Line_1:Line 1 Rtu 1` `Point Name - Line 1 Rtu 1` `Alias - LINE 1 RTU 1`
	AIN	Attribute Name	Type	DE Type	Possible Values
Device Independent (required)	0	device poll types	scalar	rtBYTES4	32 bit mask
	1	device PRBX types	scalar	rtBYTES4	32 bit mask
	2	scan input control	scalar	rtLOGICAL	0=disabled, 1=enabled
	3	scan input status	scalar	rtUINT8	§Scan Device Point
	4	failure threshold	scalar	rtUINT8	0 to 31
	5	scan input	table		(see below)
	6	scan output control	scalar	rtLOGICAL	0=disabled, 1=enabled
	7	scan output status	scalar	rtUINT8	§Scan Device Point
	8	scan output	table		(see below)
	9	dev fail threshold	scalar	rtUINT16	0 to 65,535
Device Dependent (Modbus scan task specific)	10	device address	scalar	rtUINT8	0 to 255
	11	intercharacter TO	scalar	rtUINT16	0 to 65,535
	12	prbx register	scalar	rtUINT16	0 to 65,535
	13	prbx reset register	scalar	rtUINT16	0 to 65,535
	14	debug level	scalar	rtUINT8	0 to 8
	15	swap bytes	scalar	rtUINT8/rtUINT16	(see below)
	16	clear stats	scalar	rtLOGICAL	0=no clear, 1=clear
	17	device stats	vector	rtUINT32	(see below)
Optional	.
	.
	.