Configuring the Oracle Scan Device Point

The following table outlines the device-dependent information that you must configure in the scan device point for the OracleScanner:

Pathname - . . . :scan configuration:Line_1:Line 1 Rtu 1
Point Name - Line 1 Rtu 1
            
Alias - LINE 1 RTU 1
  AIN Attribute Name Type DE Type Possible Values
Device Independent (required) 0 device poll types scalar rtBYTES4 32 bit mask
1 device PRBX types scalar rtBYTES4 32 bit mask
2 scan input control scalar rtLOGICAL 0=disabled, 1=enabled
3 scan input status scalar rtUINT8 §Scan Device Point
4 failure threshold scalar rtUINT8 0 to 31
5 scan input table   (see below)
6 scan output control scalar rtLOGICAL 0=disabled, 1=enabled
7 scan output status scalar rtUINT8 §Scan Device Point
8 scan output table   (see below)
9 dev fail threshold scalar rtUINT16 0 to 65,535
Device Dependent (Oracle scan task specific) 10 oracle table name scalar rtBYTES48 (see below)
11 transfer direction scalar rtUINT8 (see below)
12 cross ref table table   (see below)
13 debug level scalar rtUINT8 0 to 8
14 sql filename scalar rtBYTES32 (see below)
15 sql file interval scalar rtUINT32 (see below)
16 sql file path scalar rtBYTES80 (see below)
17 no attr ok scalar rtLOGICAL (see below)
18 check message q scalar rtLOGICAL (see below)
19 if file append scalar rtLOGICAL (see below)
20 initial hist read scalar rtLOGICAL (see below)
21 device stats vector rtUINT32 (see below)
Optional .        
.        
.        

See also: