Configuring the Scan Device Point

The following table outlines the device-dependent information that you must configure in the scan device point for the DNPScanner:

`Pathname - . . . :scan configuration:Line_1:Line 1 Rtu 1` `Point Name - Line 1 Rtu 1` `Alias - LINE 1 RTU 1`
	AIN	Attribute Name	Type	DE Type	Possible Values
Device Independent (required)	0	device poll types	scalar	rtBYTES4	32 bit mask
	1	device PRBX types	scalar	rtBYTES4	32 bit mask
	2	scan input control	scalar	rtLOGICAL	0=disabled, 1=enabled
	3	scan input status	scalar	rtUINT8	§Scan Device Point
	4	failure threshold	scalar	rtUINT8	0 to 31
	5	scan input	table		(see below)
	6	scan output control	scalar	rtLOGICAL	0=disabled, 1=enabled
	7	scan output status	scalar	rtUINT8	§Scan Device Point
	8	scan output	table		(see below)
	9	dev fail threshold	scalar	rtUINT16	0 to 65,535
Device Dependent (DNP 3.0 scan task specific)	10	remote ID	scalar	rtUINT16	0 to 65535
	11	comm info	table		(see below)
	12	comm optimization	scalar	rtLOGICAL	0=no opt, 1=opt
	13	message timeout	scalar	rtUINT16	0 to 65535
	14	message retries	scalar	rtUINT8	0 to 255
	15	phone number	scalar	rtBYTES32	(see below)
	16	clear stats	scalar	rtLOGICAL	0=no clear, 1=clear
	17	debug level	scalar	rtUINT8	0 to 8
	18	datalink confirm	scalar	rtLOGICAL	0=no confirm, 1=confirm
	19	enable class assign	scalar	rtLOGICAL	0=no class assign, 1=class assign
	20	enable class unsol	scalar	rtLOGICAL	0=no class unsol, 1=class unsol
	21	poll sets timestamp	scalar	rtLOGICAL	0=no ts, 1=poll sets ts
	22	IIN	scalar	rtUINT16	(see below)
	23	device stats	vector	rtUINT32	(see below)
Optional	.
	.
	.