Configuring the Turbo Rogue GPS Scan Device Point

The following table outlines the device-dependent information that you must configure in the scan device point for the RogueGPSScan:

`Pathname - . . . :scan configuration:Line_1:Line 1 Rtu 1` `Point Name - Line 1 Rtu 1` `Alias - LINE 1 RTU 1`
	AIN	Attribute Name	Type	DE Type	Possible Values
Device Independent (required)	0	device poll types	scalar	rtBYTES4	32 bit mask
	1	device PRBX types	scalar	rtBYTES4	32 bit mask
	2	scan input control	scalar	rtLOGICAL	0=disabled, 1=enabled
	3	scan input status	scalar	rtUINT8	§Scan Device Point
	4	failure threshold	scalar	rtUINT8	0 to 31
	5	scan input	table		(see below)
	6	scan output control	scalar	rtLOGICAL	0=disabled, 1=enabled
	7	scan output status	scalar	rtUINT8	§Scan Device Point
	8	scan output	table		(see below)
	9	dev fail threshold	scalar	rtUINT16	0 to 65,535
Device Dependent (Turbo Rogue GPS scan task specific)	10	elevation mask	scalar	rtUINT8	0 to 60
	11	nav mode	scalar	rtUINT8	1=Status, 2=Kinematic, 3=Clock
	12	GDOP limit	scalar	rtUINT8	0 to 99
	13	sample rate	scalar	rtUINT8	1 to 15 seconds
	14	osc steering	scalar	rtUINT8	0=External, 1=Internal
	15	time base	scalar	rtUINT8	0=UTC,1=GPS
	16	configure	scalar	rtUINT8	0=OSS0,1=OSS2,2=Normal
	17	enable sv	scalar	rtUINT8	(see below)
	18	disable sv	scalar	rtUINT8	(see below)
	19	data format	scalar	rtUINT8	0=TB
	20	data blocks	scalar	rtUINT8	0=None,1=TR, 2=ANT,4=EPH
	21	reference	vector	rtDOUBE	(see below)
	22	clock offset	scalar	rtDOUBLE	(see below)
	23	init	table	rtUINT8	(see below)
	24	debug level	scalar	rtUINT8	0 to 8
	25	clear stats	scalar	rtLOGICAL	0=Don't clear, 1=Clear
	26	device stats	vector	rtUINT32	(see below)
Optional	.
	.
	.